ORTE 2010 - Thermoplastic Orthoses

1. A. Model forming
   1. lower-limb and spinal models
   2. angular changes to negative models
   3. modifications to plaster models
2. B. Vacuum form thermoplastic orthoses
   1. components
   2. aligning joints to model
   3. vacuum forming thermoplastic
3. C. Trim lines and finishing edges
   1. rough trim
   2. definitive trim lines
   3. edges

1. A. vacuum form thermoplastic over a variety of plaster models of lower limb and spinal sections.
2. B. fabricate a variety of articulating thermoplastic orthoses.
3. C. establish trim lines and finish edges of thermoplastic orthoses.

Courses and Registration